vufka
New member
Hi all,
I don't know where to post this but wanted to write this out somewhere on here in case it helps someone. I had a really difficult time flashing my game and followed advice from all over this forum and Facebook. It turns out there was an issue with one of my cartridges? I will update this thread if/as I get new information.
I ordered two carts from INL. One works great and flashes fine, loads on real hardware. Amazing! Exactly same procedure and method, the other gets stuck at bank 4 and ends with an error. I have submitted a support ticket with INL but wanted other users on here to be aware since at least one other person experienced this on Facebook: "already tried with the 3, flashcart.bat flashcart_newargs.bat and flashcart_oldmethod.bat, none seem to work, the newargs one gets a little further doing PRG bank 0 and 4, but on 8 it fails"
Here is the relevant output from the command prompt:
Programming PRG-ROM flash
writting PRG bank: 0 of 31.0
writting PRG bank: 4 of 31.0
[ERROR] (source/usb_operations.c:308: errno: No such file or directory) Write xfr failed with libusb error: Input/Output Error
[ERROR] (source/inlprog.c:372: errno: None) cannot run config. file: memory allocation error: block too big
Fatal error encountered, exiting.
F:\NES\nesmaker\Flasher\INL-retro-progdump_map30\host>pause
Press any key to continue . . .
I don't know where to post this but wanted to write this out somewhere on here in case it helps someone. I had a really difficult time flashing my game and followed advice from all over this forum and Facebook. It turns out there was an issue with one of my cartridges? I will update this thread if/as I get new information.
I ordered two carts from INL. One works great and flashes fine, loads on real hardware. Amazing! Exactly same procedure and method, the other gets stuck at bank 4 and ends with an error. I have submitted a support ticket with INL but wanted other users on here to be aware since at least one other person experienced this on Facebook: "already tried with the 3, flashcart.bat flashcart_newargs.bat and flashcart_oldmethod.bat, none seem to work, the newargs one gets a little further doing PRG bank 0 and 4, but on 8 it fails"
Here is the relevant output from the command prompt:
Programming PRG-ROM flash
writting PRG bank: 0 of 31.0
writting PRG bank: 4 of 31.0
[ERROR] (source/usb_operations.c:308: errno: No such file or directory) Write xfr failed with libusb error: Input/Output Error
[ERROR] (source/inlprog.c:372: errno: None) cannot run config. file: memory allocation error: block too big
Fatal error encountered, exiting.
F:\NES\nesmaker\Flasher\INL-retro-progdump_map30\host>pause
Press any key to continue . . .